New in this version

• Stock transfer strategies Secondary Spindle Chuck and Secondary Spindle Return added. Also remove menu entry for the old strategy Stock Transfer. #5504
• Added "Wrap Toolpath" option to 2D Contour, 2D Pocket, 2D Adaptive for creating 4-axis substituted operations.
• Using a Spot drill for drilling exposes linear feedrates. #5413
• Allow open contour selections for Slot again. #5503
• Improved behavior when specifying inconsistent tool dimensions (e.g. corner radius equal or more than half the diameter). #5493
• Fixed issue where vertical lead-out radius remained unchanged. #5365
• Fixed wrap from sketches so it supports arbitrary sketch planes. #5260
• Fix model override with a non closed curve, when doing ID turning. #4903
• Fixed wrong stock simulation issue for Standard mode when turning off shaft/holder during stock simulation.
• Fixed toolpath generation for turning operations when using a tool without holder. #5258
• Better error message when selecting cyclic geometry for Wrap Toolpath. #5259
• Fixed issue where the turning origin could be off-center if the model was not symmetric and Model Front or Model Back were chosen. #5258
• Take confinement settings into account when using model override in turning. #4900