New in this version

• The WCS Selection mode will now be set to Coordinate System automatically for a new job regardless of the user defined default when a SolidWorks coordinate system is available in the part/assembly document.
• Prevent out of memory issue when using Simulate by hard limiting toolpath expanded for drilling cycles. Simulate will fail rather than using up all memory. #4408
• Fixed issue where small chamfer feature could not be selected for drilling. #4414
• Fixed issue with wrong job parameter value affecting the WCS. #3171 #4119
• Fixed issue where drilling could fail due a SolidWorks issue. #4118
• Fixed potential crash when simulating milling toolpath in Stock Simulation. #4386

Changes to toolpath generation

• Fixed issue where Scallop could fail to generate when using a tapered tool. #4381

Changes to post processor

• Force machine retract to 60in/1500mm for generic Okuma post. The Okuma control will move the to highest position allowed without failing.
• Fixed failure when positing and using smoothing for Robodrill post.
• Fixed failure when positing and using smoothing for Fanuc incremental post.
• Fixed failure when positing and using smoothing for generic Fanuc with subprograms post.
• Fixed failure when positing and using smoothing for generic Fanuc Compact post.
• Fixed failure when positing and using smoothing for generic Fanuc post.